Polyform HTM-2 Fender, Sand, 8.5 x 21.6 in
- Brand:
- Polyform
- Part no:
- 07834817
Image: Powerboat Supply
Where to buy
Specifications
- Diameter x length
- 8.5" x 21.6"
The HTM-2 is a Polyform fender in sand, measuring 8.5 in across and 21.6 in long. A tube runs through the center, so it can hang either vertically or horizontally from the topsides or the dock. The tube ends are reinforced so a line is not pulled through if the fender gets wedged in a tight spot. Vertical ribs and extra wall thickness add strength. The HTM series is offered in 4 sizes.
Our take
The center rope tube on the HTM-2 lets you hang it vertically or horizontally, so one fender can serve a topsides rail or a dock edge. The reinforced tube ends are there to keep a line from pulling through if it gets pinched.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.
