Polyform HTM-1 Boat Fender, Sand, 6.3" x 15.5"
- Brand:
- Polyform
- Part no:
- 29279958
Image: Fisheries Supply
Where to buy
Specifications
- Diameter x length
- 6.3" x 15.5"
The HTM-1 is a Polyform fender in sand, 6.3 inches across and 15.5 inches long. A rope tube runs through the center, so it can be hung vertically or horizontally from the topsides or a dock. Vertical ribs and extra wall thickness add strength, and the tube ends are reinforced so lines are not pulled through. The eye is 5/8 inch and takes 1/2 inch line.
Our take
The center rope tube lets this 6.3 by 15.5 inch fender hang either vertically or horizontally, so the same fender can go on the topsides or the dock, hung whichever way fits. The 5/8 inch eye takes 1/2 inch line, which sets the line it hangs on.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.
