Super Gard Inflatable Vinyl Fender, 6-1/2" x 22" (Black Onyx)
- Brand:
- Taylor Made
- Part no:
- 952622
Where to buy
Specifications
- Maker's boat length
- 20 to 25 ft
- Inflation
- 2 PSI recommended
- Valve
- Rubber football needle valve; valve seats integrally molded into fender
The Super Gard is an inflatable vinyl fender from Taylor Made, sold in Black Onyx as part 952622. It is sized 6-1/2" x 22", and the maker recommends it for boats from 20 to 25 feet. Inflation is by a rubber football needle valve, with a recommended pressure of 2 PSI. The valve seats are molded into the fender rather than glued in, which the maker presents as a durability feature. The eye hole takes rope up to 5/8 inch, so check your line size before you order. If you are matching a fender to your boat, the length range and rope size are the two figures that matter most. This one is built for the 20 to 25 foot class.
Our take
This suits owners of 20 to 25 foot boats who want a plain inflatable fender with a molded-in valve seat, which should hold up better than a glued one. Skip it if your boat is outside that range, or if you run line thicker than 5/8 inch, since it will not fit the eye. Keep it at the recommended 2 PSI.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.
Other versions
| Photo | Version and size | Price and link |
|---|---|---|
| Super Gard 8-1/2 x 26 inflatable vinyl fender Diameter x length: 8.5 x 26 in · Maker's boat length: 25' to 35' · Inflation: 2 PSI | View on Amazonpaid link |
