Super Gard 8-1/2 x 26 inflatable vinyl fender
- Brand:
- Taylor Made
- Part no:
- 952824
Where to buy
Specifications
- Diameter x length
- 8.5 x 26 in
- Maker's boat length
- 25' to 35'
- Inflation
- 2 PSI
- Valve
- Rubber football needle valve
The Taylor Made Super Gard in the 8-1/2 x 26 inch size is an inflatable fender made from marine grade vinyl. Part number 952824 is listed in Black Onyx, though that colour pairing comes from the column order of the maker's table rather than a direct statement. The ribbed sides are claimed to minimise roll. The maker lists this size for boats from 25 to 35 feet and recommends 2 PSI of inflation. You inflate it through a rubber football needle valve, with the valve seats molded into the fender. The eye hole takes rope up to 5/8 inch, so check your fender line before you buy.
Our take
This suits a 25 to 35 foot boat that needs a plain vinyl fender, and the ribbed sides should help keep it from rolling. Treat the length range as a minimum: the maker says to check local conditions with your marina, so go bigger if your berth is exposed. Its main limit is that it only takes line up to 5/8 inch, and you need a football needle to inflate it.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.
Other versions
| Photo | Version and size | Price and link |
|---|---|---|
| Super Gard Inflatable Vinyl Fender, 6-1/2" x 22" (Black Onyx) Maker's boat length: 20 to 25 ft · Inflation: 2 PSI recommended | View on Amazonpaid link |
