Skipper's Locker

Jabsco 17936-0001 Neoprene Spline-Drive Impeller, 12 Blade

Brand:
Jabsco
Part no:
17936-0001

Where to buy

Specifications

Material
Neoprene
Blades
12
Outside diameter
3.75 in
Depth (width)
3.5 in
Shaft
1 in
Drive
Spline

The Jabsco 17936-0001 is a neoprene flexible impeller with 12 blades, a brass insert and a spline drive. The maker's impeller selection table lists it as profile Q. It can be fitted to most makes and models of bronze flexible impeller pumps, including engine cooling, bilge, transfer and general purpose pumps. The figures that matter when matching it to a pump are an outside diameter of 3-3/4 in (95 mm), a depth of 3-1/2 in (88.9 mm) and a shaft diameter of 1 in (25.4 mm). Check all three against the impeller you are replacing before you order.

Our take

Buy this if your pump takes a 3-3/4 in, 12-blade spline-drive impeller on a 1 in shaft and neoprene suits the job. The maker's table lists this part only in neoprene, so look at a different part number if you want another material. Its main limit is fit: it only suits pumps built around these exact dimensions, so measure the old impeller first.

From our buying guide

The impeller depends on the pump, so find it by the pump's model number. Makers' schedules differ, with some saying every year and others every 300 hours or three years, so go by the one for your engine.

Check before you buy:

  • It matches your old one on blade count, shaft diameter, outside diameter, material, drive type and depth.
  • You've checked any substitute against the pump housing, since cross-references are the makers' own claims.
  • The material suits the job. Jabsco recommends neoprene for engine cooling, and nitrile for bilge pumping and water with oil or diesel.

See all impellers

Sources