Skipper's Locker

Xantrex Freedom XC 1000 True Sine Wave Inverter/Charger

Brand:
Xantrex
Part no:
817-1050

Where to buy

Specifications

Type
Inverter charger
Continuous output
1000 W
Peak output
2000 W
Battery voltage
12 V
AC output
120 VAC
Waveform
Pure sine
Charger output
50 A
AC transfer rating
30 A

The Xantrex Freedom XC 1000 (817-1050) combines a true sine wave inverter and a battery charger in one 12 VDC unit with 120 VAC output. It puts out 1000 W continuous and surges to about 2000 W for 2 seconds for motor loads. Input voltage range for inverting is 10-18 V DC. True sine wave output suits sensitive electronics as well as motor loads. The built-in charger is rated at 50 A, and a 30 A AC transfer relay is built in, so shore power can pass through to your AC circuits. There is also an ignition control input, fed by a 12 VDC signal, that switches the inverter off when the ignition key is off. That helps if the unit sits on an engine-start battery and you don't want it left running.

Our take

This suits a small boat or tender that wants one box for charging and for running laptops, chargers, small appliances and a motor load or two. The limit is the 2 second surge: a large compressor or pump that needs a long, hard start may be too much, so size up if that is your load. At 1000 W it is not for running heavy galley gear.

From our buying guide

On a boat subpart I covers, an electrical component must not ignite fuel vapor around it unless it is isolated from gasoline fuel sources. Ignition protection is the maker's statement.

Check before you buy:

  • It can follow your battery's profile, since not every charger can follow a lithium maker's.
  • On a boat subpart I covers, each ungrounded output conductor from a battery needs a manually reset, trip-free circuit breaker or fuse within 72 inches of the battery.

See all inverters

Sources