Sherwood 15000K Neoprene Impeller Kit, 2-9/16 in
- Brand:
- Sherwood
- Part no:
- 15000K-SHW
Image: Fisheries Supply
Where to buy
Specifications
- Material
- Neoprene
- Blades
- 12
- Depth (width)
- 2 in
- Kit contents
- Impeller, gasket, o-ring, technical service guide
This Sherwood kit centres on a 12-vane neoprene impeller, 2-9/16 inches across and 2 inches wide, for a 5/8 inch shaft. Besides the impeller, the kit has a gasket, an o-ring and a technical service guide. Sherwood gives the neoprene a 130°F maximum temperature, and says one impeller can fit more than one pump application.
Our take
Because the kit includes a gasket and o-ring along with the 12-vane neoprene impeller, the seals come in the same box. Neoprene tops out at 130°F by the maker's figure, so that is the temperature to stay under.
From our buying guide
The impeller depends on the pump, so find it by the pump's model number. Makers' schedules differ, with some saying every year and others every 300 hours or three years, so go by the one for your engine.
Check before you buy:
- It matches your old one on blade count, shaft diameter, outside diameter, material, drive type and depth.
- You've checked any substitute against the pump housing, since cross-references are the makers' own claims.
- The material suits the job. Jabsco recommends neoprene for engine cooling, and nitrile for bilge pumping and water with oil or diesel.