Rule 1100 GPH Automatic Bilge Pump 27SA
- Brand:
- Jabsco
- Part no:
- 27SA
Image: www.wholesalemarine.com
Where to buy
Specifications
- Rated flow
- 1100 gal/h
- Automatic
- Electronic sensor
- Outlet
- 28.6 mm
- Voltage
- 12V
- Current draw
- 3.7 A
The Rule 27SA is a 12V automatic bilge pump rated at 1100 GPH. It finds water with an impeller-based check instead of a float switch, running for about one second every 2.5 minutes to see if there is anything to pump. The outlet is a 1-1/8 inch hose barb with a check valve built in. The figures that matter when sizing the circuit: it draws 3.7 A at 12 V, and the recommended fuse is 7.5 A. The body measures 4.7 in high, 2.9 in wide and 2.5 in deep, so it fits where a bigger pump will not. The model number is 27SA and the UPC is 042237104809.
Our take
This suits a small bilge where you want automatic pumping without a separate float switch, which means one less part to fail or foul. It is not a pick for a boat that needs a big lift, because maximum head and dry-run tolerance are not given. Check the maker's installation sheet before relying on either.
From our buying guide
Rule and Johnson both say their bilge pumps are not intended for damage control. Flow falls as the discharge head rises, and the length of the hose, its bends and any check valve reduce it further.
Check before you buy:
- The maker's own table shows the flow at head, since how much a pump loses depends on the model.
- An automatic pump also has a manual switch, which ABYC's voluntary 2005 standard calls for.
- You'll fuse it to the maker's figure.
