Skipper's Locker

Renogy 24V 2000W Pure Sine Wave Inverter RIV2420P2-12S

Brand:
Renogy
Part no:
RIV2420P2-12S

Where to buy

Specifications

Type
Inverter
Continuous output
2000 W
Peak output
4000 W
Battery voltage
24 V
AC output
120V AC, 2x AC socket and terminal block
Waveform
Pure sine

The Renogy RIV2420P2-12S is a 24 V, 2000 W pure sine wave inverter. It runs from a 24 V DC battery bank, with an input range of 23 V to 30.7 V, and gives 120 V AC at 50/60 Hz with total harmonic distortion under 3 percent. Continuous output is 2000 W, or 16.7 A AC, and the surge rating is 4000 W for 2 seconds. Output comes through two AC sockets plus a terminal block. DC connections are M8 terminals, and there is a port for a wired remote control. It shuts down at 21.8 V on low battery and 33.3 V on overvoltage, and it has overtemperature, overload, short circuit and GFCI protection. Efficiency is 89 percent at full load. It measures 16.93 x 8.99 x 3.75 in and weighs 10.14 lb (4.6 kg). Operating temperature is -20 C to 55 C, with humidity up to 95 percent, non-condensing.

Our take

This suits a 24 V house bank where you want 2000 W of clean AC for tools or galley gear, installed somewhere dry. Skip it if you run 12 V, because the maker says 24 V banks only. The main limit is the lack of a marine or IP rating and a built-in charger, and the maker says to keep it away from rain and moisture.

From our buying guide

On a boat subpart I covers, an electrical component must not ignite fuel vapor around it unless it is isolated from gasoline fuel sources. Ignition protection is the maker's statement.

Check before you buy:

  • It can follow your battery's profile, since not every charger can follow a lithium maker's.
  • On a boat subpart I covers, each ungrounded output conductor from a battery needs a manually reset, trip-free circuit breaker or fuse within 72 inches of the battery.

See all inverters

Sources