Skipper's Locker

Raymarine i50 Depth Pack with P319 Thru-Hull Transducer

Brand:
Raymarine
Part no:
E70148

Where to buy

Specifications

Mount
Thru-hull
Material
Plastic
Frequency
50/200
Power
600 W

The Raymarine i50 Depth Pack (E70148) pairs the i50 depth display with a P319 through-hull transducer. The display shows depth and tracks maximum and minimum depth along with the depth trend. Raymarine says it suits sail boats, power boats, yachts and RIBs. The display runs on 10 to 16 V dc, nominal 12 V dc. It draws under 1 W typical on its own and 2.4 W maximum with the transducer connected. The P319 is a dual-frequency 50/200 kHz transducer in a urethane housing, rated 600 W RMS, with a 30 ft (9 m) cable. Raymarine describes the plastic housing as suited to boats with fiberglass hulls.

Our take

This suits a fiberglass boat that needs a dedicated depth readout and has room for a through-hull fitting. The 30 ft cable limits how far the display can sit from the transducer, so measure your run before you buy. Skip it if you want more than depth, since this pack is built around depth alone.

From our buying guide

Raymarine's general guidance is 200 kHz for water under about 60 m (200 ft) and 50 kHz for deep water. In-hull transducers avoid a hole, but lose performance and need a solid fiberglass bottom.

Check before you buy:

  • The housing suits your hull. Airmar and Raymarine rule out plastic on a wood hull and bronze on a metal one.
  • It connects to your display, since an analog transducer needs an interface.
  • A through-hull will be fitted to the maker's guide. Garmin says its own should be installed by a qualified marine installer.

See all depth transducers

Sources