Polyform HTM-3 Fender 10.5" x 27", Graphite
- Brand:
- Polyform
- Part no:
- HTM-3 GRAPHITE
Image: Powerboat Supply
Where to buy
Specifications
- Diameter x length
- 10.5" x 27"
- Maker's boat length
- 30' - 40' (9.1 - 12.2M)
- Valve
- Polyform valve
This is the Polyform HTM-3, a hole-through-middle fender in graphite measuring 10.5" x 27". It has molded-in ribs and reinforced tube ends, and it is designed for medium-duty use. The maker lists it for boats of 30' to 40' (9.1 to 12.2M). The volume is 9.2 gallons and the weight is 7.7lb.
Our take
The maker's boat size range of 30' to 40' is the number to check first, since the 10.5" x 27" body is sized to that range. The molded-in ribs add abrasion resistance, and the reinforced tube ends are built up where the line passes through.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.