Polyform HTM-2 Fender 8.5" x 20.5", Black, with Adapter
- Brand:
- Polyform
- Part no:
- HTM-2 BLACK W/AIR ADAPTER
Image: Powerboat Supply
Where to buy
Specifications
- Diameter x length
- 8.5" x 20.5"
- Maker's boat length
- 25' - 30'
- Valve
- Polyform valve
The Polyform HTM-2 is a hole-through-middle fender, 8.5 inches across and 20.5 inches long, supplied with an inflation adapter. Vertical ribs, reinforced tube ends and extra wall thickness are part of the design. It holds 4.7 gallons, weighs 4.7 lb and is listed by the maker for boats of 25 to 30 feet. It is intended for medium-duty work at both protected and unprotected permanent moorings.
Our take
The reinforced tube ends are the useful detail on the HTM-2: with a hole through the middle, they keep the line from pulling through if the fender snags. At 8.5 by 20.5 inches and 4.7 lb it is the maker's pick for 25 to 30 foot boats.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.