Polyform HTM-1 Hole Through Middle Boat Fender
- Brand:
- Polyform
- Part no:
- 74-311-917 (not confirmed on any fetched page; the maker's HTM-1 page lists no part number)
Where to buy
Specifications
- Diameter x length
- 6.3 x 15.5 in
- Maker's boat length
- 20'-25'
The Polyform HTM-1 is a hole-through-middle boat fender from Polyform's HTM series. It measures 6.3 inches in diameter by 15.5 inches long (16 x 39.4 cm), with a circumference of 19.8 inches and a tube diameter of 0.625 inches. It holds 1.8 gallons (6.8 liters). Polyform lists a recommended boat size of 20 to 25 feet for this model. It is packed 6 pieces to a carton. Match those figures against your boat before you buy.
Our take
This suits owners of boats in the 20 to 25 foot range, which is the size Polyform gives for it. If your boat is outside that length, look at a different size in the series. The main limit is that the maker's chart gives no eye diameter, so check that against your lines before ordering.
From our buying guide
Polyform says to use at least three fenders when docking, and Taylor Made's rule of thumb is one for every 10 ft of waterline per side. Both makers hedge their size charts, so allow for your boat and where you moor.
Check before you buy:
- The size is on that maker's own chart for your boat's length.
- Your fender line suits the eye, since Polyform says too small a line can cut through a vinyl eye.
- You'll inflate it to the maker's figure, since two makers say over-inflating voids the warranty.
