Interstate 31-AGM7 Pure Lead AGM 12V Deep Cycle Battery
- Brand:
- Interstate
- Part no:
- 31-AGM7
Where to buy
Specifications
- Chemistry
- AGM
- Role
- Dual purpose
- Voltage
- 12 V
- Dimensions (L x W x H)
- 13 x 6 13/16 x 9 7/16 in (approx 330 x 173 x 240 mm)
- BCI group
- 31T
- Terminals
- Top terminal
- Capacity
- 100 Ah
- Cold cranking amps
- 925 A
- Cranking amps (CA / MCA)
- 1155 CA
- Reserve capacity
- 200 min
- Warranty
- 36 month free replacement
The Interstate 31-AGM7 is a 12 V pure lead AGM battery in group size 31T. The maker calls it a 2-in-1 design that delivers high cranking and extreme deep-cycle power, so it is a dual-purpose battery rather than a pure starter. The figures that matter: 100 Ah capacity, 925 cold cranking amps, 1155 cranking amps, and 200 minutes of reserve capacity at 25 amps. It measures 13 inches long, 6 13/16 inches wide and 9 7/16 inches high (about 330 x 173 x 240 mm), with top terminals. It carries a 36 month free replacement warranty. Check the footprint and terminal layout against your battery box before you order.
Our take
This suits someone who wants one 12 V battery to both crank an engine and carry house loads, and who has a group 31T space with top terminals. If you need a dedicated deep-cycle bank or a dedicated starter, a single-purpose battery is the cleaner choice. The main limit is that the maker does not name marine use, so confirm it suits your application.
From our buying guide
A starting battery delivers a short burst of strong power, a deep-cycle battery a low, steady level for longer, and a dual-purpose battery a balance of the two. Buy for the job it will do.
Check before you buy:
- You've measured the tray against the maker's real dimensions, since a BCI group gives maximum sizes and some batteries sold as a drop-in run longer.
- You're comparing the same rating. Cold cranking amps are tested at 0°F and cranking amps at 32°F, so the second number is higher.
- If it's lithium, the maker says whether it may start an engine, and NMMA advises contacting your boat's manufacturer or a certified technician before replacing lead-acid.
