Skipper's Locker

EPEVER Tracer4215BN 40A MPPT solar charge controller

Brand:
EPEVER
Part no:
Tracer4215BN

Where to buy

Specifications

Type
Mppt
Battery voltages
12V and 24V, auto-detected (8-32V battery input range)
Charge current
40 A
Maximum panel voltage
150 V
Maximum panel power
520W at 12V, 1040W at 24V
Ingress rating
IP30

The EPEVER Tracer4215BN is a 40A MPPT solar charge controller from the Tracer-BN series. It takes a battery bank of 12V or 24V and detects the system voltage automatically, with a battery input range of 8 to 32V. Rated charge current is 40A and discharge current is 20A. Battery types are Sealed (the default), Gel, Flooded and User-defined. On the panel side, maximum open circuit voltage is 150V at the lowest operating temperature, or 138V at 25C. Rated charge power is 520W at 12V and 1040W at 24V, and maximum PV input power is the same. The maker quotes tracking efficiency of 99.5% or more and conversion efficiency up to 98.0%. It talks RS485 Modbus over an RJ45 port, runs from -35C to +55C, and measures 302.5 x 182.7 x 63.5 mm. The enclosure is rated IP30.

Our take

This suits a 12V or 24V boat with a decent array and a dry spot to mount it, such as inside a cabin locker, where the maker's efficiency figures and Modbus monitoring port are useful. Skip it if it must live somewhere exposed: IP30 is a protected-location rating. The datasheet mentions no marine certification or built-in Bluetooth, and the MT50 display is an optional extra.

From our buying guide

NMMA says charging sources must meet the charging profile the battery maker recommends. A charger's presets are its own maker's, so set it from the battery maker's figures.

Check before you buy:

  • It can follow your battery's profile, since not every charger can follow a lithium maker's.
  • On a boat subpart I covers, each ungrounded output conductor from a battery needs a manually reset, trip-free circuit breaker or fuse within 72 inches of the battery.

See all solar controllers

Sources