EPEVER Tracer1210AN 10A MPPT solar charge controller
- Brand:
- EPEVER
- Part no:
- Tracer1210AN
Where to buy
Specifications
- Type
- Mppt
- Battery voltages
- 12/24VDC auto
- Charge current
- 10 A
- Maximum panel voltage
- 100 V
- Maximum panel power
- 130W at 12V, 260W at 24V
- Ingress rating
- IP30
The EPEVER Tracer1210AN is a 10A MPPT solar charge controller from the maker's Tracer-AN series. It runs on a 12/24V system with automatic voltage detection and handles sealed, gel and flooded lead-acid as well as lithium (LiFePO4 and others), plus a user-defined setting. The maker quotes charge conversion efficiency as high as 98%, and the controller cuts charging power back when it runs hot. The figures that matter when choosing: rated charge power is 130W on a 12V system and 260W on 24V. Maximum PV open circuit voltage is 100V, measured at the minimum operating temperature. The MPP voltage range runs from battery voltage plus 2V up to 72V. Grounding is common negative. Enclosure rating is IP30. It talks Modbus over RS485 on an RJ45 port. The maker's manual says to disconnect the PV array before the battery when working on the wiring.
Our take
This suits a small dry-mounted setup: a modest panel array on a 12V or 24V bank, kept to about 130W or 260W. Skip it for larger arrays, since 10A caps it, or for exposed spots, since IP30 is not weatherproof. Size your panel string for cold-weather open circuit voltage against the 100V limit.
From our buying guide
NMMA says charging sources must meet the charging profile the battery maker recommends. A charger's presets are its own maker's, so set it from the battery maker's figures.
Check before you buy:
- It can follow your battery's profile, since not every charger can follow a lithium maker's.
- On a boat subpart I covers, each ungrounded output conductor from a battery needs a manually reset, trip-free circuit breaker or fuse within 72 inches of the battery.
