AIMS Power PWRI150012120S 1500W 12VDC Pure Sine Power Inverter
- Brand:
- AIMS Power
- Part no:
- PWRI150012120S
Image: www.aimscorp.net
Where to buy
Specifications
- Type
- Inverter
- Continuous output
- 1500 W
- Peak output
- 3000 W
- Battery voltage
- 12 V
- Waveform
- Pure sine
The AIMS Power PWRI150012120S is a pure sine inverter that runs from a 12 V battery, with a 9.8 to 16 V input range. It is rated for 1500 W continuous and 3000 W surge for 40 ms. The maker's figures are under 3% total harmonic distortion, over 90% efficiency and 0.8 A no-load current. It has three AC outlets and one USB port, 5 V at 1 A maximum. The maker recommends 4 AWG or larger cable and a 150 A inline DC fuse. Cables are not included. A remote on/off switch is optional, part REMOTEHF. The unit shuts down at 9.5 V low battery, above 16 V input, and on over temperature at 149 F. It is conformal coated against moisture and corrosion, but has no IP rating. It is ETL listed to UL 458 and CSA 22.2 No. 107.1, measures 15.88 x 9.38 x 3.8 in and weighs 10 lb.
Our take
This suits a 12 V boat that needs a 1500 W pure sine inverter for cabin loads, with a solid battery bank and short, thick cables to feed it. Keep it out of the engine room, bilge and fuel areas: the maker lists no IP or ignition-protection rating, and water must not reach it. It is not for positive-ground systems. Its main limit is current draw, so your battery and wiring decide what you can really run.
From our buying guide
On a boat subpart I covers, an electrical component must not ignite fuel vapor around it unless it is isolated from gasoline fuel sources. Ignition protection is the maker's statement.
Check before you buy:
- It can follow your battery's profile, since not every charger can follow a lithium maker's.
- On a boat subpart I covers, each ungrounded output conductor from a battery needs a manually reset, trip-free circuit breaker or fuse within 72 inches of the battery.
