Sikaflex-291i one-component polyurethane marine sealant
- Brand:
- Sika
- Part no:
- 291i
Image: Aquafax product photo
Where to buy
Specifications
- Type
- 1-component polyurethane, moisture-curing
- Volume
- 300 ml
- Cure time
- Skin time about 60 minutes at 23 C and 50% r.h.; full cure time not stated as a figure in the data sheet
Sikaflex-291i is a non-sag, one-component polyurethane sealant that Sika developed for the marine market. It cures on atmospheric moisture, is sea water and hydrolysis resistant, is solvent free, and meets the IMO low spread of flame requirements. It comes in white, grey, black and brown, and a 300 ml cartridge is one of the pack sizes. Skin time is about 60 minutes at 23 C and 50% relative humidity, and tooling and finishing must be done within that skin time. Apply it between 10 and 40 C. Cure slows in the cold because the air carries less moisture. Once cured it stays elastic, with 700 percent elongation at break and Shore A hardness of 40, and it handles service temperatures from -50 to 90 C. Shelf life is 15 months stored below 25 C.
Our take
This suits elastic, vibration-resistant joint seals and bonding where the stress is limited, which is how Sika positions it. Skip it for PMMA or PC plastics, and for any spot where fuel, oil, solvents or strong acids will reach it. Paint is usually less elastic than the sealant and may crack over the joint. Expect slow curing in cold weather.
See all sealants and adhesives
