Skipper's Locker

Crosby G-209 Screw Pin Anchor Shackle, 5/16 in

Brand:
Crosby
Part no:
1018393

Where to buy

Specifications

Size
0.3125 in
Material and finish
Forged, quenched and tempered body with alloy pin; mechanically galvanized at 5/16 in
Working load limit
3/4 t (carbon)

Crosby's galvanized screw pin anchor shackle at 5/16 in, stock number 1018393: forged, quenched and tempered, with an alloy pin, and mechanically galvanized at this size. Crosby lists a working load limit of 0.75 (t) with a 6:1 design factor, says the limit is reduced for side loading, and shows the limit and Grade 6 permanently on every shackle. Crosby says the G-209 meets or exceeds all requirements of ASME B30.26.

Our take

A small forged shackle with a 3/4 t working load limit and a 6:1 design factor, so the rating carries real margin. The WLL and grade are marked on the body, and the maker says it meets ASME B30.26. At 5/16 in the galvanizing is mechanical, not hot-dip, so expect less corrosion protection than the larger sizes. No spare pin is listed, so a worn pin means a new shackle. Buy it for light loads inside that rating, and size up for anything heavier.

From our buying guide

An older Campbell catalogue, writing about welded chain, says shackles should have at least the working load limit of the chain they are used with. If not, the assembly is rated to its weakest component.

Check before you buy:

  • The maker states a working load limit and how it's worked out, since Crosby lists a 6:1 design factor and Mantus one fifth of the breaking strength.
  • That limit holds the way you'll load it, since Crosby says it is reduced for side loading.

See all shackles

Sources